Used Sinotruk Howo Dump Tipper Truck

Tire specification: 12.00-20 radial tire; or 12.00R20 steel tire   Engine: sinotruk electric EGR third emission engine (336 HP)       

 Clutch: gf420j Steyr project imported, heavy duty truck Ф 420 spiral spring reinforced clutch, equipped on 266-336ps engine       

Imported Clutch - reinforced Ф 430 imported diaphragm clutch, equipped on 375-420ps engine           

Transmission: SINOTRUK howo15710 transmission, 10 forward gears, 2 reverse gears, torque 1500nm.   

Drive axle: ac16 double reduction casting engineering drive axle, speed ratio: 5.45, the engineering vehicle bridge developed by sinotruk after three years. Its reliability and bearing capacity have been greatly optimized. In 2010, it is only standard for dump trucks.          

Front axle: hf9 front axle, integral steering front axle, mainly composed of front I-beam, knuckle, main pin, knuckle arm and trapezoid arm.    

Top loading part: the special large compartment of SINOTRUK dump truck, all plates are made of alloy materials. The thickness of the longitudinal beam of the subframe is 8mm, and the material is Q345. The thickness of the transverse and vertical bars of the upper and lower frames of the side plate and the back door of the underframe of the dump truck is 6mm. The channel steel structure of the back door. Four longitudinal beams at the bottom reinforced. 

Inspection and maintenance before starting the engine ：

The cooling system adopts a closed forced water cooling system and uses long-term coolant.(Coolant is poisonous, avoid inhalation in human body during use, storage and preparation. It is not allowed to open the expansion tank cap immediately after the engine is stopped, so as not to be disturbed by the internal high warm pressure gas burns.If the coolant is greatly reduced during the use of the vehicle, causing the entire system to overheat, at this time

Do not add coolant immediately, as sudden changes in coolant temperature can damage the engine. Even if there is no antifreeze requirement in the area where the vehicle is used (the temperature is above the freezing point all the year round), also does not allow water to replace cooling coolant use. Unscrew the drain plug at the radiator, The vehicle coolant can be emptied,Engine coolant bleed. (2)Cooling system (check daily) The vehicle must be parked on a level road with the front hood open. Observe the liquid level of the expansion tank, the coolant level should be between the high and low marks on the side of the expansion tank.(3)Fill coolant, Unscrew the expansion tank cap to relieve the cooling system pressure. Slowly turn the expansion tank cap counterclockwise half a turn, Remove the expansion tank cap. Turn the heater temperature adjustment button switch to the maximum heater position. Fill coolant up to MAX. Put the expansion tank cap on and tighten it. Let the engine run for a while. Check the coolant level and replenish if necessary.